MASTERSON SUPERPRO SPONGE REFILL(3)

The key to success with yourSta-Wet Palette is the proper preparation of the palette. Follow these 5 steps to ensure great results every time! 1) Prepare the Sta-Wet Acrylic Paper Prepare the Sta-Wet Acrylic paper by placing a sheet of Mastersons acrylic paper in the sink and turn on the HOT water. Do not use the sink stopper;let the water drain over the paper and out of thesink.. Allow the hot water to run directly onto thepaper for 45-60 seconds. The paper will becomesemi-transparent. 2) Wet the Sponge The sponge material has been compressed. Once you moisten it withwater, it will expand to 1/4 thickness. The firsttimeyou use the sponge, rinse it thoroughly toremoveany adhesives used during the processing of the sponge. Doing so will extend the life of thesponge.Then, fully saturate the sponge with COLDwater. DO NOT WRING OUT THE SPONGE. Place the wetsponge inthepalette tray. If the sponge is too large for the tray when it is wet, wring the sponge out and trimitto fit with a pair of scissors. Then saturate thesponge again with cold water andlay itin the tray. 3) Place a Wet Piece of Sta-Wet Acrylic Palette Paper Place a wet piece of Sta-Wet Acrylic palettepaper on top of the sponge anduse a paper towel of soft cloth to wipe off the excess moisture from thetop surface of the paper. 4) PlaceYour Paints on the Paper The paints will slowly absorb moisture from the sponge, through the paper.Darkerpaint colors may bleed back into th